Battery Replacement

Removal Procedure

Important

Record pre-set radio stations.

1. Disconnect the negative battery cable.
2. Disconnect the positive battery cable.
3. Remove the battery insulating cover.
4. Remove the battery hold down bracket.

Caution

Do not tip the battery over a 45 degree angle or acid could spill causing serious personal injury.

5. Remove the battery.

Installation Procedure

1. Verify the battery tray is clean.
2. Install the battery.

Notice

Refer to Fastener Notice in Cautions and Notices.

3. Install the battery hold down bracket.
Tighten

Tighten the battery case bracket stud and nut to 9 N·m (80 lb ft).

Notice

Battery life is reduced if a battery insulation cover is not used.

4. Install the battery insulating cover.
5. Verify the battery cable ends are clean and free of corrosion. Clean with a wire brush.
6. Connect the positive battery cable.
Tighten

Tighten the battery terminal bolts to 17 N·m (13 lb ft).

Important

Set the clock and radio pre-set stations.

7. Connect the negative battery cable.
Tighten

Tighten the battery terminal bolts to 17 N·m (13 lb ft).