Rear Exterior Door Panel is Not Tight Against the Door Structure #96-T-19C - (Jan 10, 2003)

Rear Exterior Door Panel is Not Tight Against the Door Structure -- Adjust the Door Structure Flange -- Due to revisions under Models Affected, this bulletin supersedes bulletin 96-T-19B, which should be discarded.

1996-1999 Saturn Sedans and Wagons.

Condition:

The rear upper corner of the rear exterior door panel does not stay tight against the door structure, causing a loose, non-flush condition.

Cause:

The rear door side window outer sealing strip does not tightly hold the top of the exterior door panel to the door structure.

Correction:

Remove the rear door side window outer sealing strip and adjust the door structure flange according to the procedures in this bulletin.

Procedures:

Click here for detailed picture of above image.

Remove the retaining screw from the rear side door window frame front applique.

Starting at the front, gently lift the rear side door window outer sealing strip, disengaging it from the door structure and exterior door panel.

Important

A putty knife with the blade covered with tape may be used to gently pry the rear side door window outer sealing strip from the flange.

Cover the rear side door quarter vent glass with a thickly padded material, taping the material into place to avoid movement.

Using a wedge of wood and a light hammer, tap on the rear edge of the rear door structure flange, moving it inboard towards the center of the vehicle. The only part of the flange that should be moved is the part that is slightly curved. The amount of movement will vary according to the looseness of the panel.

Important

Do not change the position of the flange anywhere forward of the rear window glass channel.

Install the rear side door window outer sealing strip to the door and inspect the fit and flushness against the door structure. If required, adjust the flange again, using the procedure in step 4, until the side door window outer sealing strip is tight against the door structure.

Press the rear side door window outer sealing strip onto the outer belt flange.
Inspect the alignment at the front edge of the door.

Notice

Fastener Notice

Install the rear side door window frame front applique lower screw and tighten.

Tighten

Tighten the screw to 2 N·m (18 lb in).

CLAIM INFORMATION	To receive credit for this repair, submit a claim through the Saturn dealer System as follows:
--	Case Type	Description	Labor Operation Code	Time
--	VW	Adjust the Rear Door Structure Flange -- Right Side	T9701	0.30 hrs
--	VW	Adjust the Rear Door Structure Flange -- Left Side	T9702	0.30 hrs

GM bulletins are intended for use by professional technicians, NOT a "do-it-yourselfer". They are written to inform these technicians of conditions that may occur on some vehicles, or to provide information that could assist in the proper service of a vehicle. Properly trained technicians have the equipment, tools, safety instructions, and know-how to do a job properly and safely. If a condition is described, DO NOT assume that the bulletin applies to your vehicle, or that your vehicle will have that condition. See your GM dealer for information on whether your vehicle may benefit from the information.

WE SUPPORT VOLUNTARY TECHNICIAN CERTIFICATION