.
The following diagnosis might be helpful if the vehicle exhibits the symptom described in the PI.
Technician complains of no transaxle fluid pressure after transaxle is reassembled (converter housing and main case were separated). Fluid MAY spray from transaxle dipstick tube with dipstick removed and engine running.
Replace damaged or missing pump-to-case O-ring seal located between the converter housing and main case near transaxle dipstick tube.
.
Please follow this diagnosis process thoroughly and complete each step. If the condition exhibited is resolved without completing every step, the remaining steps do not need to be performed. If these steps do not resolve the condition, please contact GM TAC for further diagnostic assistance.
(91, 92, 93, 94, 95, 96, 97, 98, 99, 00, 01, 02 Saturn S-series MP6 and MP7)
.
GM bulletins are intended for use by professional technicians,
NOT a "do-it-yourselfer". They are written to inform these
technicians of conditions that may occur on some vehicles, or to
provide information that could assist in the proper service of a
vehicle. Properly trained technicians have the equipment,
tools, safety instructions, and know-how to do a job properly and
safely. If a condition is described, DO NOT assume that the
bulletin applies to your vehicle, or that your vehicle will have
that condition. See your GM dealer for information on whether
your vehicle may benefit from the information. |
WE SUPPORT VOLUNTARY TECHNICIAN CERTIFICATION |
© Copyright General Motors Corporation. All Rights Reserved.