Notice
Pressure bleeding equipment must be of the diaphragm type. It must have a rubber
diaphragm between the air supply and the brake fluid to prevent air, moisture, and
other contaminants from entering the hydraulic system.
Notice
Use only DOT 3 brake fluid from a clean, sealed container. Do not use any fluid
from a container which is wet with water. Do not use DOT 5 silicone fluid.
- Clean the brake fluid reservoir cap and the area around the cap.
- Remove the cap.
- Fill the master cylinder reservoir with clean brake fluid.
- Install the
SA9150BR
,
or equivalent, to the brake fluid reservoir.
- Connect the
J 29532
,
or equivalent, to adapter.
- Charge the pressure bleeder equipment to 138-172 kPa (20-25 psi).
- Perform steps 2-6 of the
Hydraulic Brake System Bleeding
, skipping steps involving brake pedal
operation.