Document ID# 1218373
1998 Saturn SL2/SC2/SW2
 

Design Changes to Automatic Transaxle Control Solenoid Valve #97-T-41A - (Jan 6, 2003)

Service Information on Design Changes to Automatic Transaxle Control Solenoid Valve. Due to part interchangeability, this bulletin supercedes bulletin 97-t-41, which should be discarded.

1993-1998 and 1999 Saturn vehicles built up to and including VIN XZ154760 equipped with automatic transaxles (MP6/MP7)

Note: Vehicles built after the VIN break have control solenoid valves with an additional filter on the control side of the solenoid. They are currently being used in all five solenoid locations and can be identified by a white top. The control solenoid valves were previously only used in the 2nd/Rev, 3rd, and 4th gear clutch locations on 1997 - 1998 vehicles.

Purpose

This bulletin provides technical information on changes to the automatic transaxle control solenoid valve.

Control solenoid valve, (P/N 21003289), can now be used as a service part back to the 1993 model year and can be used in all five solenoid locations on the valvebody.

Parts Information

21003289 - Valve - Trans Cont Actr (93-99)

 

GM bulletins are intended for use by professional technicians, NOT a "do-it-yourselfer".  They are written to inform these technicians of conditions that may occur on some vehicles, or to provide information that could assist in the proper service of a vehicle.  Properly trained technicians have the equipment, tools, safety instructions, and know-how to do a job properly and safely.  If a condition is described, DO NOT assume that the bulletin applies to your vehicle, or that your vehicle will have that condition.  See your GM dealer for information on whether your vehicle may benefit from the information.
WE SUPPORT VOLUNTARY TECHNICIAN CERTIFICATION

© Copyright General Motors Corporation.  All Rights Reserved.


  Document ID# 1218373
1998 Saturn SL2/SC2/SW2