Windshield Garnish Molding Replacement 1st Design Coupe

Removal Procedure

Important

1. Remove the instrument panel upper trim panel. Refer to Trim Plate Replacement - Instrument Panel (I/P) Upper in Instrument Panel, Gages, and Console.




2. For the left side windshield garnish molding, remove the seat belt retractor cover by pulling at the clip locations.
3. Starting at the upper rear section of the molding, pull firmly at the clip locations to disengage the molding from the vehicle.

Installation Procedure

Important

1. Place the forward edge of the molding to the windshield pillar base. Align the clips and push firmly to engage the molding clips at the forward edge of the vehicle.
2. For the left side windshield garnish molding, install the seat belt retractor cover.
3. Install the instrument panel upper trim panel. Refer to Trim Plate Replacement - Instrument Panel (I/P) Upper in Instrument Panel, Gages, and Console.